Table of Contents
Advertisement
5.2.3
AUX Connector
8
1
Table-3
Pin configuration for Hirose 10P
No
I/O
Name
1
O
TTL OUT2
2
O
TTL OUT3
3
I
TTL IN2
4
NC
5
GND
6
I
LVDS IN1+
7
I
LVDS IN1-
8
NC
9
GND
10
GND
5.3
Digital In and out inteface
In the SP-20000-CXP2, the software control tool can assign the necessary signals used in the system to
digital inputs and outputs.
5.3.1
Line Selector
In the Line Selector, the following input and output signals can be assigned.
Table – 4
Line Selector
Line Selector item
Line 1 TTL OUT 1
Line 2 OPTO OUT 1
Line 8 TTL OUT 2
Line 10 TTL OUT 3 t
NAND 0 In 1
NAND 0 In 2
NAND 1 In 1
NAND 1 in 2
Note: In the line source, input interfaces besides those mentioned above will be shown but
the line source setting is not available. The input interface can be configured in the trigger
source and the pulse generator source.
SP-20000M-CXP2 / SP-20000C-CXP-2
Hirose 10-Pin connector
Type: HIROSE 10-Pin Connector 3260-10S3(55)
Fig. 4
Hirose 10p connector
Description
TTL output from #9 pin of DC In/Trigger HIROSE 12-Pin on the rear
Optical output from #7 and 8 pins of DC In/Trigger HIROSE 12-Pin on the rear
TTL output from #1 pin "AUX" HIROSE 10-Pin on the rear
TTL output from #2 pin "AUX" HIROSE 10-Pin on the rear
First input at first NAND gate in GPIO
Second input at first NAND gate in GPIO
First input at second NAND gate in GPIO
Second input at second NAND gate in GPIO
Note
Line8
Line9
Line10
Line11
- 13 -
Advertisement
Table of Contents
