When Controlling The Exposure Time Using The Pulse Width Of The Trigger Input Signal - IAI GO-2401M-PGE User Manual

4
Set [Trigger Mode] to [On].
5
If necessary, change the [Trigger Source], [Trigger Activation], and [Exposure Auto]
settings.

When Controlling the Exposure Time using the Pulse Width of the Trigger Input Signal

Configure the settings as follows.
Trigger Selector (trigger operation)
Trigger Mode
Trigger Source (trigger signal source)
Trigger Activation (trigger polarity)
Exposure Mode
1
Set [Exposure Mode] to [Trigger Width] .
When you select [Trigger Width], [Trigger Mode] will automatically be set to [On].
2
Set [Trigger Selector] to [Frame Start].
([Frame Start] is the default setting.)
3
If necessary, change the [Trigger Source] and [Trigger Activation] settings.
Other controls
In addition to exposure time, the following can also be controlled by external triggers. Select these
control operations in [Trigger Selector].
[Trigger Selector] setting
Acquisition Start
Acquisition End
Acquisition Transfer Start
Item
— 19 —
Setting value / selectable range
Frame Start
On
Any
Level High (high-level duration), Level Low (low-level
duration)
Trigger Width (control via trigger width)
Start image acquisition.
Stop image acquisition.
Output acquired images at a specified timing. (Up to 7
frames for 8-bit, and up to 3 frames for 10-/12-bit.)
GO-2401M-PGE / GO-2401C-PGE
Description