Table of Contents
Advertisement
5.2
Connectors and pin assignment
5.2.1
Digital Video Output (75Ω 1.0・2.3 DIN Receptacle)
Type: CoaXPress Connector (ACX1785-ND Amphenol Connector or equivalent)
CXP#1
CXP#2
Maximum Bit Rate per one coax: 6.25 Gbps
Maximum Bit Rate per two coax: 12.5 Gbps
Note: If one coaxial cable is used, CXP#1 must be used.
5.2.2
12-Pin connector
5.2.2.1
Figure
Fig.3
Hirose 12-pin connector
5.2.2.2
Pin configuration
Table – 2 12-pin configuration
Pin no.
Signal
1
GND
2
DC input
3
GND
4
NC
5
OPTO IN-
6
OPTO IN+
7
OPTO OUT -
8
OPTO OUT+
9
TTL out 1
10
TTL In 1
11
DC input
12
GND
Note 1) Factory default setting is Exposure Active and negative
Note 2) Factory default setting is trigger input.
Note 3) See page 6 for notes about power options for these cameras
Note: If power is supplied from both the 12-pin connector and CoaXPress, the power from the 12-pin is
active. If power from the 12-pin is interrupted, the operation depends on how power was initially
connected. Please refer to the following:
The order of power supply connections
First 12-pin, then CoaXPress
First CoaXPress, then 12-pin
SP-20000M-CXP2 / SP-20000C-CXP-2
PoCXP compliant
Type: HR-10A-10R-12PB(72) Hirose male or equivalent.
Remarks
+12V ～ +24V (note 3)
Line 5
Line 2
Line1 (note 1)
Line4 (note 2)
+12V ～ +24V (note 3)
If the power supply from 12-pin is interrupted
The power is supplied from CoaXPress
The power is supplied from CoaXPress but the
camera is not restarted.
- 12 -
Advertisement
Table of Contents
