Mitsubishi Electric MR-J4W2 Instruction Manual page 318

14. USING A LINEAR SERVO MOTOR
(2) Servo system controller setting
(a) Setting precautions
The following parameters will be enabled by turning the servo amplifier power off and on again after
the controller writes the parameters to the servo amplifier.
Command resolution
Servo amplifier setting
Motor setting
(Note)
No.
Symbol
PA01 **STY
PC01 ERZ
PC03 *ENRS
PC27 **COP9 Function selection C-9
PL01 **LIT1
PL02 **LIM
PL03 **LID
Parameter
PL04 *LIT2
PL05 LB1
PL06 LB2
PL07 LB3
PL08 *LIT3
PL09 LPWM
PL17 LTSTS
PL18 IDLV
Unit setting
Positioning
control
Number of pulses (AP)
parameter
Travel distance (AL)
Note. The parameter whose symbol is preceded by * is enabled with the following conditions:
* : After setting the parameter, power off and on the servo amplifier or reset the controller.
**: After setting the parameter, cycle the power of the servo amplifier.
Setting item
Name
Operation mode
Error excessive alarm level
Encoder output pulse selection
Linear servo motor/DD motor function
selection 1
Linear encoder resolution - Numerator
Linear encoder resolution -
Denominator
Linear servo motor/DD motor function
selection 2
Position deviation error detection level
Speed deviation error detection level
Torque/thrust deviation error detection
level
Linear servo motor/DD motor function
selection 3
Magnetic pole detection voltage level
Magnetic pole detection - Minute
position detection method - Function
selection
Magnetic pole detection - Minute
position detection method -
Identification signal amplitude
Motion controller
R_MTCPU/Q17_DSCPU
Initial
value
1000h
0
0000h
0000h
0301h
1000
1000
0003h
0
Set the items as required.
0
100
0010h
30
0000h
0
Refer to (2) (b) of this section.
14 - 23
Setting
Simple motion module
RD77MS_/QD77MS_
Linear encoder resolution unit
MR-J4-B Linear
Automatic setting
1040h
mm