Mitsubishi Electric MR-J4W2 Instruction Manual page 515

APPENDIX
App. 5.9 LED display
I/O status, malfunction and power on/off are displayed with LED for each A-axis and B-axis.
App. 5.10 Rotary switch setting
Rotary switch is used to shut off the power after control stop by SS1 function.
Set the delay time for STO output after STO shut off switch is pressed. Set same setting for SW1 and SW2,
and set the rotary switch setting according to the delay time in the table below.
Setting cannot be changed while power is on. Notify users that setting cannot be changed by putting a seal
or by another method so that end users will not change the setting after the shipment.
0 to F in the following table is the set value of the rotary switches (SW1 and SW2).
0 s
1.4 s
2.8 s
A-axis
5.6 s
9.8 s
30.8 s
LED
Monitor LED for start/reset
SRES Off: The start/reset is off. (The switch contact is opened.)
On: The start/reset is on. (The switch contact is closed.)
Monitor LED for shut-off 1
SDI1 Off: The shut-off 1 is off. (The switch contact is closed.)
On: The shut-off 1 is on. (The switch contact is opened.)
Monitor LED for shut-off 2
SDI2 Off: The shut-off 2 is off. (The switch contact is closed.)
On: The shut-off 2 is on. (The switch contact is opened.)
Monitor LED for STO state
TOF Off: Not in STO state
On: In STO state
Monitor LED for SDO1
SDO1 Off: Not in STO state
On: In STO state
Monitor LED for SDO2
SDO2 Off: Not in STO state
On: In STO state
Monitor LED for confirming shutdown delay setting
SW Off: The settings of SW1 and SW2 do not match.
On: The settings of SW1 and SW2 match.
FAULT LED
FAULT Off: Normal operation (STO monitoring state)
On: Fault has occurred.
Power supply
POWER Off: Power is not supplied to MR-J3-D05.
On: Power is being supplied to MR-J3-D05.
Rotary switch setting and delay time at A/B-axis [s]
0 s 1.4 s
0 1
-
App. - 32
Definition
B-axis
2.8 s 5.6 s
2 -
5 -
8 -
-
LED
Column Column
A B
A-axis B-axis
9.8 s 30.8 s
3 4
6 7
9 A
B C
D E
F