Mitsubishi Electric MR-J4W2 Instruction Manual page 370

16. FULLY CLOSED LOOP SYSTEM
Symbol Name
f) Motor side cumu. feedback
pulses (before gear)
g) Encoder information
h) Polarity
i) Z phase pass status
j) Fully closed loop changing
device
k) Parameter (Feedback pulse
electronic gear)
l) Parameter (Dual feedback
filter)
m) Parameter (fully closed loop
selection)
Feedback pulses from the servo motor encoder are counted and displayed. (Servo
motor encoder unit)
When the set value exceeds 999999999, it starts with 0.
Click "Clear" to reset the value to 0.
The "-" symbol is indicated for reverse.
The load-side encoder information is displayed.
The display contents differ depending on the load-side encoder type.
ID: The ID No. of the load-side encoder is displayed.
Data 1: For the incremental type linear encoder, the counter from powering on is
displayed. For the absolute position type linear encoder, the absolute
position data is displayed.
Data 2: For the incremental type linear encoder, the distance (number of pulses) from
the reference mark (Z-phase) is displayed. For the absolute position type
linear encoder, "00000000" is displayed.
For address increasing direction in the servo motor CCW, it is indicated as "+" and for
address decreasing direction in the servo motor CCW, as "-".
If the fully closed loop system is "Disabled", the Z-phase pass status of the servo motor
encoder is displayed. If the fully closed loop system is "Enabled" or "Semi closed loop
control/fully closed loop control switching", the Z-phase pass status of the load-side
encoder is displayed.
Only if the fully closed loop system is "Semi closed loop control/fully closed loop control
switching", the device is displayed.
The state of the semi closed loop control/fully closed loop control switching bit and the
inside state during selection are displayed.
Display/set the feedback pulse electronic gears ([Pr. PE04], [Pr. PE05], [Pr. PE34], and
[Pr. PE35]) for servo motor encoder pulses in this parameter. (Refer to section 16.3.1
(4).)
Display/set the band of [Pr. PE08 Fully closed loop dual feedback filter] in this
parameter.
Display/set the parameter for the fully closed loop control.
Click "Parameter setting" button to display the "Fully closed loop control - Basic"
window.
1)
3)
1) Fully closed loop selection ([Pr. PE01])
Select "Always valid" or "Switching with the control command of controller" here.
2) Feedback pulse electronic gear ([Pr. PE04], [Pr. PE05], [Pr. PE34], [Pr. PE35])
Set the feedback pulse electronic gear.
3) Selection of encoder pulse count polarity ([Pr. PC27])
Select a polarity of the load-side encoder information.
16 - 23
Explanation Unit
pulse
2)