Table of Contents
Advertisement
Available languages
Available languages
Transport
Before each transport:
− switch off device
− wait until the cutting device does not longer
move
Carry the device balanced on the shaft or hanging from the
carrying strap.
To avoid injuries or damages, secure the cutting
blade (7) and thread knife (10) against touching by mounting
the respective transport guard (7a and 10a).
When transporting the product in a car put it only in the boot
or on a separate loading area. Do not throw the device when
loading it. Secure the device against tipping over, damages
and fuel spillage.
Check the device for damages if it was subjected to hard
jolts during transport.
Storage
Keep unused machines in a dry and closed area out of the
reach of children.
Always store the machine in places where gasoline vapour
cannot come into contact with open flames or sparks (e. g.
not close to a stove, oven or water heater with pilot light).
Allow the engine to cool down before storing the machine.
To store the device do not rest it on the protective hood but
best store it suspended. You may swivel the handles inward
to safe space.
Secure the cutting blade (7) with the transport guard (47).
Note the following to extend the service life of the device
and to ensure smooth operation:
Normal storage
Storage of the device during a working break (working break not
longer than 6 weeks).
1. Carry out a thorough cleaning and maintenance.
2. Check the device for perfect condition to ensure reliable
use.
3. Empty the fuel tank completely.
Always drain the tank in the open or in sufficiently
ventilated rooms.
Dispose of remaining fuel in an environmentally
compatible manner.
4. Operate the engine until the carburettor is empty.
Start the engine for this purpose and allow it run at idle
speed until it stops. The carburettor now contains no more
fuel.
Fuel residues in the carburettor may cause starting
problems or damages.
5. Allow the engine to cool down.
6. Treat all movable parts with an environmentally friendly oil
Never use any grease!
30
Long-term storage
Storing the device during an operating break of several months,
e.g. winter break.
First carry out steps 1
6
Normal storage
–
"
7. Remove the spark plug connector.
8. Remove the spark plug. Then fill a little amount of engine oil
(approx. 1 teaspoon) into the cylinder. Slowly pull out the
cranking rope handle to distribute the oil. Re-mount the
spark plug.
Before any use of the device you have to remove
and clean the spark plug.
Guarantee
Please observe the enclosed terms of guarantee.
.
"
Advertisement
Chapters
Table of Contents
