ControlMaster CM10, CM30 and CM50
Universal process controllers,
...Profile Parameters / ...Enter Program / ...Enter Segments
Ramp Time
Step
End
Period
Setpoint
Ramp Rate
78
1
1
1
/
,
/
and
/
DIN
8
4
2
Increases or decreases the setpoint at a linear rate until the desired value is reached ( (if Ramp
Type = Time
. A Ramp Time segment requires the user to enter the desired end setpoint and the
)
desired ramp duration in hh:mm:ss.
Changes the setpoint value from the end value to of the previous segment to a new value. A Step
segment requires the entry of the Step setpoint value.
Ends the program.
Select the soak or ramp period of the segment in hhh:mm:ss.
Note. Only displayed if Segment Type is configured as Soak or Ramp time.
Select the required end setpoint value for the segment in engineering units.
Note. Only displayed if the Segment Type is configured as Ramp Rate or Ramp Time.
Select the required Ramp Rate for the segment.
Note. Only displayed if Segment Type is Ramp Rate.
7 Advanced Level
IM/CM/S–EN Rev. R