ABB ControlMaster CM10 User Manual page 55

ControlMaster CM10, CM30 and CM50
Universal process controllers,
...Control / ...Loop 1 Setpoints
RSP Fault Action
No Action
Local
Local Default
Default Setpoint
Ramp Mode
Ramp Rate
Select Sources
LSP 1/2 Toggle
IM/CM/S–EN Rev. R
1 1 1
/ , / and / DIN
8 4 2
The action required when a fault occurs with the remote setpoint.
No fault action.
Selects the local (internal) setpoint mode.
Selects the local (internal) setpoint mode and sets its value to the default setpoint.
Sets the value required for the local (internal) setpoint under remote setpoint fault conditions.
See Basic Level, page 28.
See Basic Level, page 28.
Selection of local setpoints and changing the setpoint mode (between local [internal] and remote
[external]) can be controlled by digital signals; either from internal digital signals (for example, alarm
states) or from external signals via digital inputs (or digital communications) – see Appendix A.1,
page 116 for description of sources.
The (level-triggered) source required to select either local
setpoint 1 (LSP1) or local setpoint 2 (LSP2). A low signal locks the
local setpoint as LSP1; a high signal locks it as LSP2.
7 Advanced Level
LSP2
LSP1
LSP1
53