ABB ControlMaster CM10 User Manual page 74

ControlMaster CM10, CM30 and CM50
Universal process controllers,
...Profile Parameters / ...Common Settings
Ramp Control
Ramp Type
Rate
Time
Ramp Units
Program Control
Run
Hold
72
1 1 1
/ , / and / DIN
8 4 2
Selects the Ramp Type required. The ramp type selected applies to all programs / segments.
The profile set point can be configured to increment in one of two way: for a fixed period of time
or for a number of engineering units per hour.
Defined as rate / time unit (hr, min, sec).
Defined in hr:min:sec.
Selects the ramp rate time units required (Units/min, Units/hr, Units/sec).
Selects the digital source used to start the program. The program is started on the rising edge.
Run
Selects the digital source used to put the program into 'Operator hold' mode.
Hold mode is entered on the rising edge.
Hold
7 Advanced Level
IM/CM/S–EN Rev. R