ABB ControlMaster CM10 User Manual page 76

ControlMaster CM10, CM30 and CM50
Universal process controllers,
...Profile Parameters / ...Common Settings / ...Program Control
Recovery
Action
Continue
Repeat
Reset
Advance
Time
74
1 1 1
/ , / and / DIN
8 4 2
Selects the profile restart action when power is restored after a failure or the PV is restored
after a failure and the Recovery Period (Time – see below) has expired.
The program resumes from the point at which failure occurred and is placed in
Operator Hold mode.
The program resumes from the start of the current segment and is placed in
Operator Hold mode.
The program resumes from the start of the current program and is placed in
Operator Hold mode.
The program resumes at the point in the program that would have been reached if no power
failure had occurred in Run mode.
Note. If a zero time period is selected the program will always recover with the chosen option.
Set the recovery time period used to determine the recovery action.
The time is configurable in HH:MM:SS.
7 Advanced Level
IM/CM/S–EN Rev. R