ABB ControlMaster CM10 User Manual page 75

ControlMaster CM10, CM30 and CM50
Universal process controllers,
...Profile Parameters / ...Common Settings / ...Program Control
Reset
Run / Hold
Stop
Skip
Repeat
IM/CM/S–EN Rev. R
1 1 1
/ , / and / DIN
8 4 2
Selects the digital source used to reset a running program. The program is reset on a rising edge.
If the program was running, it will run from the start. If the program was held it will remain held at
the start point.
Reset
Selects the digital source used to start and hold the program. The program runs when the input
is high and holds when the input is low.
Run
Hold
Selects the digital source used to stop the program. The program is stopped on the rising edge.
Stop
Selects the digital source used to skip to the next segment. The segment is skipped on the rising
edge.
Skip
Selects the digital source used to repeat the current segment. The segment is repeated on the
rising edge.
Repeat
7 Advanced Level
73