ABB ControlMaster CM10 User Manual page 40

ControlMaster CM10, CM30 and CM50
Universal process controllers,
...Device Setup
Security Setup
Basic Password
Advanced Password
Reset Passwords
Custom Config
Loop 1 (2) PV
Loop 1 (2) Split O/P
Loop 1 (2) Valve Mode
Loop 1 (2) Valve O/P
Loop 1 (2) Valve FB
Loop 1 (2) TP OP1
Loop 1 (2) TP OP2
Loop 1 (2) RSP
38
1 1 1
/ , / and / DIN
8 4 2
2 Security access levels are provided, each protected by a password of up to 6
alphanumeric characters.
Note. Passwords are not set at the factory and must be entered by the end user(s).
Basic level provides access to the Basic level – see Section 6, page 27.
Provides access to all configuration parameters – see Section 7, page 36.
Resets all passwords to factory values.
Sets the source for the process variable.
Sets the source for output to the split output function block.
Sets the valve operation mode, Feedback or Boundless – see page 32.
Sets the control input to the valve function block.
Sets the source for position feedback input.
Sets the source for control input to the time proportioning block for Output 1 – see page 36.
Sets the source for control input to the time proportioning block for Output 2 see page 36.
Sets the source for the remote (external) setpoint.
7 Advanced Level
IM/CM/S–EN Rev. R