ABB ControlMaster CM10 User Manual page 78

ControlMaster CM10, CM30 and CM50
Universal process controllers,
...Profile Parameters / ...Enter Program
Setpoint Start/End
Start
End
Local Setpoint
Hold Setpoint
Holdback
Hysteresis
Soak
Ramp
76
1 1 1
/ , / and / DIN
8 4 2
The start setpoint value for the first segment of the program.
Note. Available only if the SPT Start Condition parameter is set to Program Setpoint.
Defines the end condition of the program:
The program will enter the Stop state and switch to the currently selected Local Setpoint.
The program remains active and in control at the setpoint defined by the last segment. It remains
active until stopped, at which point the Control Setpoint switches to the current Local Setpoint.
Hysteresis values are used to hold the program when the process value deviates from the
setpoint by more than the hysteresis value as defined by the Guaranteed Ramp option for each
segment.
Note. Available only if Guaranteed Ramp is enabled.
Set the hysteresis value applied to Soak segments.
Set the hysteresis value applied to Ramp segments.
7 Advanced Level
IM/CM/S–EN Rev. R