Ethernet Params; Ascii Data Port - Printronix P8000 Series Administrator's Manual

IP Assignment
This menu provides two options to control IP Assignment: DHCP and BootP.
•
DHCP. You can enable/disable the DHCP protocol using this option, but consult your administrator
for the appropriate setting. Options include Disable and Enable (factory default).
•
BootP. You can enable/disable the BootP protocol using this option, but consult your administrator
for the appropriate setting. Options include Disable (factory default) and Enable.

Ethernet Params

Ethernet
Params
(from page 88)
ASCII
Data Port
9100* 5001*
1025 - 65535 1025 - 65535
The Ethernet Params menu helps your printer communicate on a network.
For information on assigning the IP Address, Gateway Address, Subnet Mask, and MAC Address, refer to
the Network Interface Card User's Manual.

ASCII Data Port

This option sets the port number for ASCII print jobs. The data port number needs to match your host
system setting.
•
9100 (factory default)
•
1025 - 65535
IPDS Data Port
This option allows you to set the port number for IPDS print jobs only if the IPDS option is installed.
•
5001 (factory default)
•
1025 - 65535
Keep Alive Timer
This is the time that the Keep Alive Timer will run. With the Keep Alive Timer on, the tcp connection will
stay connected even after the print job has terminated.
•
3 Minutes (factory default)
•
0 - 10 Minutes
88
*=
Factory Default
1
If installed.
IPDS Data Keep Alive
1
Port Timer
3 Minutes*
0 – 10 Minutes
Ethernet
Job Control
Speed
Auto Select* Standard*
10 Half Duplex Enhanced
10 Full Duplex Fast Standard
100 Half Duplex Off
100 Full Duplex
Offline
Process
Disable*
Enable