Installing the QCMC
CAUTION
You must power off the printer before you install or remove the QCMC, or you may
damage the QCMC and the printer. If you remove the QCMC after powering on the
printer with the QCMC installed, the fault message "SD REMOVED Reboot Printer"
will display. You cannot clear this message by reinserting the QCMC. You must
cycle power.
1. Set the printer power switch to O (Off).
2. Insert the SD card into the QCMC slot on the back of the printer.
310
Figure 53 QCMC Slot on Back of Cabinet Model
5
4
3
2
9
8
7
Figure 54 QCMC Clost on Back of Pedestal
QCMC Slot
1
6
QCMC Slot