Printronix P8000 Series Administrator's Manual page 256

Displayed Message
CLEARING PROGRAM
FROM FLASH
CLOSE PLATEN
COIL HOT ERR 1
COIL HOT ERR 2
COIL TEMP FAIL
CARTRIDGE CONNECTION
ERROR
See User Manual
CARTRIDGE
INCOMPATIBLE
Use correct cart
CARTRIDGE MISSING
Install new cart
Press ONLINE
256
Table 23 LCD Message Troubleshooting Table (ASCII)
Can User
Correct?
No
Yes
No
Yes
No
Yes
Yes
Explanation
Status message:
emulation software
successfully loaded into
printer RAM and the
checksum matched. The
old program is now
being deleted from flash
memory.
The platen lever is open.
One or more hammer
coils are overheating.
The coil temperature
was never set or the
attempt to set it did not
result in correct
numbers.
The hardware cannot
communicate properly
with the cartridge.
An incompatible ribbon
cartridge was installed in
the printer.
The ribbon cartridge is
missing or installed
improperly.
Solution
No action is required.
Close the platen lever.
Contact your authorized
1
service representative.
Allow printer to cool
completely, then set coil
temperature. If message
continues to display,
contact your authorized
1
service representative.
1. Make sure the ribbon
cartridge is seated
properly.
2.
Remove and replace
the ribbon cartridge if
necessary.
3.
Contact your
authorized service
1
representative.
Install a cartridge designed
for this printer.
1. Make sure a ribbon
cartridge is installed in
the printer.
2.
Make sure the ribbon
cartridge is seated
properly.
3.
Remove and replace
the cartridge if
necessary.
4.
Contact your
authorized customer
service representative.
1