Printronix P8000 Series Administrator's Manual page 205

Pwr Save Control
Allows you to enable or disable the Power Save mode.
•
Enable (factory default). Allows you to enable the Power Save mode.
•
Disable. Allows you to disable the Power Save mode.
Cancel Key
•
Disable
•
Enable (factory default). The CANCEL key may be used to clear all data in the print buffer without
printing any of the data.
Rcv. Status Port
This option defines the interface being used to receive the emulation status command.
•
Automatic (factory default). When selected, the status command is sent to the printer with the print
data through the active host interface.
•
Serial. When selected, the status command is sent to the printer through the serial interface
regardless of the active host interface.
Ret. Status Port
This option selects the port for the Return Status Commands (i.e., ~STATUS for PGL) to send the status
data back to the Host.
The options are Automatic (factory default), Serial, USB, E-NET Stat Port, IEEE 1284, Disable, and E-
NET Data Port.
Set Lock Key
Normally, to lock or unlock the printer menu, the UP and DOWN keys are pressed at the same time. The
Set Lock Key parameter lets you choose different keys to lock or unlock the printer menu. You may
choose almost any group of keys as the new lock and unlock keys. You cannot use the ENTER key or
any key combinations which are already used for another function. There is no limit to how many keys
you can select.
To set the new lock key, follow these steps:
1. Work your way through the configuration menu until the display reads "Set Lock Key" (follow the
menu structure on page 194).
2. Press ENTER. The display reads, "Select a new lock key."
3. Press the combination of keys you want to be the new lock key. Make sure you press all keys
selected at the same time.
4. If the selection is valid, the display will read, "Enter the new lock key again." If the selection is invalid,
the display will read, "Invalid key selection." Return to step 2 and start over.
5. Press the same combination of keys a second time. If the new lock key combination is entered again
correctly, the display will read, "Lock key has been changed." If it was entered incorrectly, the display
will read "Verification failed." Start over at step 2.
6. After entering the new lock combination successfully, press the ONLINE key to put the printer back
online.
NOTE: The new lock combination will remain even if the printer is powered off and back on.
Job Sel/Typeface
NOTE: For H-Series printers only.
205