Printronix P8000 Series Administrator's Manual page 277

Table 24 LCD Message Troubleshooting Table (H-Series)
Displayed Message
450:SD FILE FULL
File Too Big
451:SD NOT FOUND
Insert SD Card
Pwr Off Printer
452:SD FILE FULL
Delete Files
453:SD READING
Do not Remove
454:SD WRITING
Do not Remove
607:CTL VOLT FAIL*
608:DRIVER CIRCUIT
BAD
609:EXHAUST
FAN CHECK
(Cabinet model only)
613: HAM. COIL BAD
#, #, #, ...etc
614:HAMMER BANK*
NOT INSTALLED
Can User
Explanation
Correct?
Yes A write operation to the SD
has failed because the file is
too big to fit in the remaining
space on the SD card.
Yes A write operation to the SD
could not be performed
because the SD card was
not detected.
Yes The SD file system is
completely full.
Yes The SD card is currently
reading files.
Yes The SD card is currently
writing or erasing files.
No Controller Voltage Failure.
15 V failure on the controller
board.
No Driver Circuit Bad. The
hammer coil count test
failed.
Yes Sensor cannot detect current
in fan circuit.
No Hammer coil # failed current
test at power up.
No Hammer Bank Not Installed.
Self-test routines do not
detect hammer coils at
printer start-up.
Solution
Delete files on the SD card to
make space.
Ensure that an SD card is
inserted correctly and that the
SD card is a supported SDHC
card.
Delete files on the SD card to
make space.
Wait until reading completes.
Wait until the write or erase
operation completes.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Power off the printer and remove
the paper path (see Maintenance
Manual). Check that the fan cable
connector is connected. Check
for obstruction of vents and fan
airway, and remove any
obstructions. Check for items
beneath the printer blocking
cabinet vents. Power back on the
printer. If this message appears
again, contact your authorized
1
service representative.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
277