Printronix P8000 Series Administrator's Manual page 287

Table 24 LCD Message Troubleshooting Table (H-Series)
Displayed Message
NON VOLATILE
MEMORY FAILED
ONLINE
PANEL
BAD CHECKSUM
PARAMETER ERROR* No
PLAT DRVR CIR
PLEASE WAIT...
RESET IN
PROGRESS
PRINTER UNDER
REMOTE CONTROL
PROCESSOR
HALTED
EC_FAULT_RTSYS2
REMOVE USED SPX
THEN PRESS ENTER
RESTORING BOOT
CODE
SCS COMMAND
ERROR*
Can User
Explanation
Correct?
No Large emulations reduce the
amount of space available
for saving configurations,
which means that sometimes
fewer than eight
configurations can be saved.
N/A Printer state message:
printer is online and in
communication with host.
No Panel Code has a bad
Checksum.
Illegal parameter value
received in command code
over a TN emulation.
No Platen driver circuit
malfunction.
N/A Status message: the printer
finished loading the program
into flash memory and is
automatically resetting itself.
No Status message: The printer
is under the control of
PrintNet Enterprise (PNE)
remote management
software.
No Real-time System Firmware
error on controller board.
No Status message: An SPX is
depleted because it has
successfully reprogrammed
the security key on the
controller board.
No Normal download
initialization message.
No In the TN emulation, the
printer received undefined
control character (hex 40).
Solution
Contact your authorized service
1
representative.
No action is required.
Reload released firmware.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
No action is required.
No action is required.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
No action is required.
Contact your system
administrator.
287