Printronix P8000 Series Administrator's Manual page 268

Displayed Message
PS/PDF ERROR:
STACK ERROR
PS/PDF ERROR:
SYNTAX ERROR
PWR SUPP VOLT *
REMOVE USED SPX
THEN PRESS ENTER
RESTORING BOOT CODE
RIB INVLD CMD*
See User Manual
RIBBON STALL
RIBBON UNDER 2%
Change RBN Soon
268
Table 23 LCD Message Troubleshooting Table (ASCII)
Can User
Correct?
Yes
Yes
No
No
No
Yes
Yes
Yes
Explanation
Fault displayed when
Postscript/PDF failed to
process a job. One or
more of the following
errors were detected:
Stack Overflow, Stack
Underflow, Exec Stack
Overflow, or Invalid
Restore.
Fault displayed when
Postscript/PDF failed to
process a job. One or
more of the following
errors were detected:
Syntax Error, Unmatched
Mark, Undefined,
Undefined Results, or
Unknown Error.
Power Supply Voltage.
The power supply has
failed.
Status message: An SPX
is depleted because it has
successfully
reprogrammed the
security key on the
controller board.
Normal download
initialization message.
Ribbon Invalid
Command. Firmware
error on the controller
board.
The controller board
does not detect ribbon
movement.
Status message
indicating the Integrated
Print Management
System is enabled and
ribbon ink level is 2%.
Solution
Check the Postscript/PDF job
for syntax (Postscript) errors.
Clear the fault. Postscript/PDF
will continue with the next job.
Check the Postscript/PDF job
for syntax (Postscript) errors.
Clear the fault. Postscript/PDF
will continue with the next job.
Replace power supply board.
Contact your authorized
1
service representative.
No action is required.
Cycle power. Run the print
job again. If the message
appears, download the
emulation software again. If
the message appears again,
contact your authorized
1
service representative.
Check the ribbon path for
jams. Turn the Ribbon
Tension Knob clockwise a
few rotations. If necessary,
install a new ribbon.
Install a new ribbon.