Printronix P8000 Series Administrator's Manual page 276

Table 24 LCD Message Troubleshooting Table (H-Series)
Displayed Message
432:CRT NOT SET
435:NO WELD
See User Manual
437:REG MISSING
Use Correct RBN
438:TIP MISMATCH
Use Correct RBN
439:SHTL MISMATCH
Use Correct RBN
445:SD INSERTED
Reboot Printer
446:SD REMOVED
Reboot Printer
447:SD FL EXIST
Enable Overwrite
448:SD WRT. FAIL
WRITE PROTECTED
Check SD Card
449:SD FILE WRITE
Check SD
276
Can User
Explanation
Correct?
Yes The ribbon cartridge is not
correctly positioned.
No The cartridge weld was not
detected.
Yes The incorrect cartridge type
is being used for the printer.
Yes The incorrect cartridge type
is being used for the printer.
Yes This message displays when
an Extended Life Ribbon is
mounted on a 500 lpm
printer.
Yes The SD card has been
inserted after the printer was
already powered up.
Yes The SD card has been
removed after the printer
was already powered up.
Yes A write operation to the SD
has failed because the file
already exists on the SD
card and the overwriting of
existing files is disabled.
Yes A write operation to the SD
has failed because the SD
card is write protected.
Yes A write operation to the SD
has failed for an unknown
reason.
Solution
1. Make sure a ribbon
cartridge is installed in the
printer.
2.
Make sure the ribbon
cartridge is seated properly.
3.
Remove and replace the
cartridge if necessary.
4.
Contact your authorized
customer service
1
representative.
Contact your authorized service
1
representative.
Install region X ribbon cartridge
in the printer.
NOTE: Specify the region of
the printer when
ordering ribbons.
Install the correct ribbon
cartridge type in the printer.
Install Standard Life Ribbon.
Turn off the printer and insert the
SD card only when the printer is
not powered on.
Turn off the printer and remove
the SD card only when the
printer is off.
Enable overwriting of files on the
SD using the overwrite files
menu.
Ensure that the write protect tab
on the SD card is not active. If the
write protect tab is not active, use
another SD card.
Ensure that the SD card is
inserted correctly and that the
SD card is a supported SDHC
card.