Printronix P8000 Series Administrator's Manual page 271

Table 23 LCD Message Troubleshooting Table (ASCII)
Displayed Message
SHUTTLE TYPE
NOT SUPPORTED*
SOFTWARE ERROR*
CYCLE POWER
SPX FOUND, ERROR:
KEY NOT DETECTED
SPX NOT NEEDED
OPTIONS ENABLED
TCB CORRUPTED*
TCP PORT BUSY
UP DRV. SHORT*
UPGRADED - REMOVE SPX
Downld code if needed
WELD NOT DETECT
See User Manual
WELD SNSR ERROR
See User Manual
Can User
Explanation
Correct?
No The shuttle type was not
detected at power-up or
the shuttle installed in the
printer is not supported by
the firmware.
No Application software tried
to perform illegal printer
function, or damaged logic
circuits found on controller
board.
No The controller board does
not have a security key.
No The user has attempted
to use the SPX to turn
on printer options that
are already enabled.
No Task Control Block
Corrupted. Firmware
error on controller board.
Yes Error message reported
by the Printer Manager
when ethernet interface
option is installed. The
network address given in
the printer properties
was reached, but the
printer port is busy.
No Upper Driver Short.
Hammer driver circuits
on the boards shorted to
ground.
No Status message: An SPX
has successfully
upgraded the
security key on the
controller board.
No The cartridge weld was
not detected.
No The cartridge sensor
could not be calibrated.
Solution
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Refer to the Printronix P8000
Maintenance Manual.
Cycle power to see if the
message clears, if not, contact
your authorized service
1
representative.
Remove SPX and download
code if needed.
Contact your authorized
1
service representative.
1. Make sure your cartridge
is properly seated.
2.
Contact your authorized
service representative.
1
271