Printronix P8000 Series Administrator's Manual page 262

Displayed Message
FLASH: WAS NOT
CLEARED
FLASH: WRITE ERROR # 2
FM HEADER ERROR*
FRAMING ERROR
GENERATING XX%
NAND FLASH TABLE
H00: PCI SLOT ?
See User Manual
H01: PCI J12
See User Manual
262
Table 23 LCD Message Troubleshooting Table (ASCII)
Can User
Correct?
No
No
No
Yes
No
No
No
Explanation
Printer encountered an
error while trying to
program Flash memory.
Printer encountered an
error while trying to
program Flash memory.
Frame Header Error.
Application software has
violated header
parameters.
The printed output may
contain random !
(exclamation point)
characters.
NAND FLASH is being
read and system tables
are being initialized.
The controller board is
not communicating with
a PCI card. This could
indicate a bad PCI card,
poor connection, or
problem in the PCI bus.
The controller board is
not communicating with
the PCI card in PCI slot
J12. This could indicate
a bad PCI card, poor
connection, or problem
in the PCI bus.
Solution
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your system
administrator.
Make a configuration printout.
Set printer serial interface
parameters to match host
configuration settings for
Data Protocol, Baud Rate,
Data Bits, Stop Bits, Parity,
Data Terminal Ready, and
Request to Send.
No action is required.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.