Testing Telephones; Testing Trunks - Avaya G430 Installation And Upgrades

After installation
Testing data connectivity
About this task
Test data connectivity by pinging the IP address of each device to test the device's connectivity
within the network and outside the network.
Related links
Installation testing on page 63

Testing telephones

Procedure
1. Make outgoing calls from the telephone.
Make sure you hear a dial tone when you pick up the receiver. Make sure you can make
both an internal (within the local network) and an external (outside the local network) call.
2. Make a call to the telephone from both within the network and outside of the network.
Related links
Installation testing on page 63

Testing trunks

About this task
Use the facility test call feature to verify that each trunk is functioning properly.
For information about how to use the facility test call feature, see Maintenance Procedures for
®
Avaya Aura Communication Manager, Media Gateways and Servers, 03-300432.
Related links
Installation testing on page 63
Testing LSP failover
About this task
If you have an S8300 Server installed in the Branch Gateway and configured as an LSP, you need
to perform a test to make sure that the LSP takes over control of the Branch Gateway if the Branch
Gateway becomes disconnected from the primary MGCs (Media Gateway Controller).
Note:
If SLS mode is enabled and the primary controller and LSP both fail, then the Branch Gateway
enters SLS mode.
Procedure
1. Verify that valid translations are file synchronized to the LSP by logging into Avaya Aura
Communication Manager from the LSP and listing either stations or trunks, see
Administering Avaya Aura
Verify that the list of stations or trunks is valid. If the files are not synchronized, verify that
you have correctly configured the required IP address(es) for the primary controller(s)
February 2017
®
Communication Manager, 03-300509.
Installation and Upgrades for the Avaya Branch Gateway G430
Comments on this document? infodev@avaya.com
®
64