Connecting Power To The Branch Gateway - Avaya G430 Installation And Upgrades

Installing the Branch Gateway and EM200
Related links
Ground conductor attachments

Connecting power to the Branch Gateway

About this task
After you have mounted the Branch Gateway, optionally mounted and connected EM200 device(s),
installed the media modules, and attached grounding conductors, you can connect power to the
Branch Gateway.
Procedure
1. Connect the power cable to the power connector on the Branch Gateway back panel.
2. Plug the power cable into an AC outlet.
The Branch Gateway is now powered.
The PWR LED on the front panel lights. The CPU LED lights up if the firmware is running. At
least one LED on each media module, except the S8300, lights up initially and then goes off
after about 20 seconds.
Related links
Ground conductor attachments
February 2017
on page 33
on page 33
Installation and Upgrades for the Avaya Branch Gateway G430
Comments on this document? infodev@avaya.com
42