Combination Limitations; Slot Allocation - Avaya G430 Installation And Upgrades

Warning:
Do not operate the Branch Gateway and EM200 with any open slots. Failure to cover empty
slots with the supplied blank plates can cause overheating due to inadequate air distribution.
Related links
Installing the media modules

Combination limitations

The Branch Gateway chassis is designed to accommodate:
• Up to three of the following telephony media modules: MM710, MM710B, MM711, MM712,
MM714, MM714B, MM720, MM722
• Up to two of the following telephony media modules: MM716, MM717
• Up to one S8300 server, in slot V1 only
Each EM200 chassis is designed to accommodate:
• Up to two of the following telephony media modules: MM710, MM170B, MM711, MM712,
MM714, MM714B, MM716, MM717, MM720, MM722
• Up to four MM721 modules
Note:
Although you can insert a total of seven MM710 or MM710B media modules in the extended
G430 (a G430 with two EM200 expansion modules), the optimum number is four MM710 or
MM710B media modules, since the Branch Gateway can support up to 100 VoIP channels.
Related links
Installing the media modules

Slot allocation

The Branch Gateway chassis has three media module slots, marked V1, V2, and
page 30).Each of the two optional EM200 expansion modules has two media module slots each
(see the figure on page 111 ). The slots of the EM200 connected to the EXPANSION OUT 1
connector on the rear of the G430 are slots V5 and V6, and the slots of the EM200 connected to the
EXPANSION OUT 2 connector on the rear of the G430 are slots V7 and
lists the permitted slots for each media module.
Allocate a slot for the media module. Make sure your slot allocations allow a permissible slot for
every media module.
February 2017
on page 28
on page 28
Installation and Upgrades for the Avaya Branch Gateway G430
Comments on this document? infodev@avaya.com
Installing the media modules
V3the figure on
V8.Table 1 on page 30
29