Proposed Solution 1 - Avaya G430 Installation And Upgrades

Proposed Solution 1

Procedure
1. Remove the Branch Gateway cover.
2. Locate the NVRAM init jumper (jumper J3801) on the front of the Branch Gateway main
board.
Refer to the figure below. Note that the jumper's two pins closest to the rear of the G430 are
bridged.
Figure 30: Branch Gateway NVRAM INIT Jumper Location
3. Move the bridge on jumper J3801 so the two pins closest to the front of the G430 are
bridged.
4. Place the G430 cover back on the unit, and close it with at least the top cover screw.
5. Reconnect the G430 power cable to the power connector at the rear of the G430.
6. Connect the G430 power cable into a mains socket.
7. Let the Branch Gateway operate for about 5 minutes so that it will boot and erase the current
configuration.
Reboot is complete when the CPU LED starts blinking.
February 2017 Installation and Upgrades for the Avaya Branch Gateway G430
Comments on this document? infodev@avaya.com
NVRAM Init
109