Firmware Specifications - Avaya G430 Installation And Upgrades

removable ground even when the AC cords are disconnected. However, because of unreliable
earthing concerns in Finland, Norway, and Sweden, the Branch Gateway must be installed in a
Restricted Access Location (RAL). An RAL is defined as an access that can be gained only by
trained service personnel or customers who have been instructed about the reasons for the
restricted access and any safety precautions that must be taken. In these cases, access to the
Branch Gateway is gained by the use of a tool (such as a lock and key) or other means of
security. If you have any questions about the safety conditions, contact your project manager.
When you have verified that the site is ready for a safe installation, proceed with the installation.
Related links
Site requirements on page 15

Firmware Specifications

New Comcode numbers for G430
Old codes will still be active for G430 with imbedded MP20 and MP80 bundle option.
• 700503274 : G430 120 channel DSP daughter board – Single MP120 for upgrades
• 700506957 : G430 MP120 Media Gateway – New bundle no on board MP20 and preinstalled
MP120
• 700506958 : G430 MP120 Media Gateway Non-GSA – New bundle number on board MP20
and preinstalled MP120
• 700508198 : G430 120 CHANNEL DSP daughter board
Minimum firmware requirements for G430
BGW 5.0 27.31.0
BGW 5.1 28.27.0
BGW 5.2 29.24.0
BGW 5.2.1 30.28.0
BGW 6.1 31.26.0
BGW 6.2.1 32.26.0
February 2017
v1a v2a
(MP120
Preinstalled)
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Installation and Upgrades for the Avaya Branch Gateway G430
Comments on this document? infodev@avaya.com
Comments Recommended CM Version
- Older versions of CM will
work
CM 5.0 (SP)
CM 5.1 (SP)
No BGW support CM 5.2 (SP)
MP120
No BGW support CM 5.2.1(SP 16) or higher
MP120
(CM blocks more than 105
channels)
No BGW support CM 6.0.1
MP120
(CM blocks more than 105
channels)
No BGW support AA 6.2 FP1 CM 6.2 sp 4 — Dec
MP120 2012
Before you install
Table continues...
17