Usb To Serial Adapter Cable Setup (Rs232 Serial Port) - GE LOGIQ 9 Technical Manual

GE M S
EDICAL YSTEMS
D 2294854-100, R
IRECTION
5-4-12-5 USB to Serial Adapter Cable Setup (RS232 Serial Port Connector on the External I/O)
The Prolific USB to RS232 Adapter Cable (black one) should be properly set up when the Base Image
Load is applied to the system. However, if you need to set a specific parameter for the USB COM Port
(COM1) perform the following steps:
-
-
-
Table 5-9
5-4-13 Outputs
Table 5-10
Signal Name
+5VDC
+12VDC
PS_ON*
Standby
SVideo
CVideo
VGA
VGA
BW Video RGB
Audio Out
TRIG
5-28
PROPRIETARY TO GE
3
EVISION
After booting up with the Service Dongle, entering Maintenance Mode and Windows, select
My Computer>Properties>Hardware Tab>Device manager.
Under Ports (COM & LPT) select "Prolific USB-to-Serail Comm/Port (COM 3)" and select
Properties.
Under the Port Settings TAB you can set the Bits per second, Data bits, Parity Stop Bits and
Flow Control to the desired values.
Factory Default Values
Signal Name
Bits Per Second
Data Bits
Parity
Stop Bits
Flow Control
Output Signals
TBD (Active Low)
Composite Color Video
VGA High Resolution Video to External Video Screen
VGA High Resolution Video to Internal Video Screen (Top
BW Video from RGB.
This signal is not used on LOGIQ™ 9
Audio Out from BEP
Video Trig Signal
Section 5-4 - Back End Processor (BEP)
Setting
9600
8
None
1
None
Description
DC Voltage
DC Voltage
TBD
SVideo Out
Console)
LOGIQ™ 9 P
ROPRIETARY
Signal Path
PC2IO > IIO
PC2IO > IIO
PC2IO > IIO > Card Rack
PC2IO > IIO > Top Console
PCVIC > PC2IO > IIO > EIO
PCVIC > PC2IO > IIO > EIO
PCVIC > PC2IO > IIO > EIO
BEP > Top Console
PCVIC > PC2IO > IIO > EIO
This signal is not used on LOGIQ™ 9
BEP > IIO > Internal VCR
BEP > IIO > EIO > External VCR
PC2IO > IIO > EIO
M
ANUAL