Conventions Used In This Manual - YOKOGAWA WT110 User Manual

Conventions Used in this Manual

IM 253401-01E
Symbols Used
The following symbol marks are used throughout this manual to attract the operator's attention.
To avoid injury or death of personnel, or damage to the instrument, the
operator must refer to the User's Manual. In the User's Manual, these
symbols appear on the pages to which the operator must refer.
Describes precautions that should be observed to prevent the danger of
WARNING
serious injury or death to the user.
Describes precautions that should be observed to prevent the danger of
CAUTION
minor or moderate injury to the user, or the damage to the property.
Note
Provides information that is important for proper operation of the
instrument.
Displayed Characters on the 7-Segment LED
In order to display all numbers and alphabetic characters on the 7-segment LED, some of them
are displayed in a slightly altered format. For details, refer to section 1.3.
Markings used for Descriptions of Operations
Relevant Keys
Operating Procedure
Explanation
An example of an Operating Procedure
(Display C)
1.
SETUP
2.
SHIFT OUTPUT
The items in this figure are obtained by the following setting procedures. The blinking part of
the display can be set.
1. After pressing the SHIFT key and the SHIFT indicator is lit, press the SETUP (OUTPUT)
key. The output setting menu will appear on display C.
2. Select rELAY using the up/down keys.
Pressing either key, 4 selectable items will be displayed consecutively.
3. Verify the setting by pressing the ENTER key.
The setting menu corresponding to the item selected at step 2 will appear at display C.
4. Select oFF or on using the up/down keys.
Pressing either key, 6 selectable items will be displayed consecutively.
5. Verify the setting by pressing the ENTER key.
Indicates the relevant panel keys and indicators to carry out
the operation.
The procedure is explained by a flow diagram. For the
meaning of each operation, refer to the example below. The
operating procedures are given with the assumption that you
are not familiar with the operation. Thus, it may not be
necessary to carry out all the steps when changing settings.
Describes settings and restrictions relating to the operation.
(Display C)
3. 5.
ENTER ENTER
End of
4.
setting
7