Mitsubishi RC-EX3 User Manual page 30

Individual flap control Select flap
Bat.set.
Flap ❶ is in operation.
Individual flap control Select flap
Flap❶ Swing range
Upper limit setting
Select the upper limit No. & tap [Set].
3
Select the number of the flap of which the motion range is changed.
(☞4)
■When there are two or more flaps at the blow
outlet, such as the FDT type, the flap at blow
outlet No. ① will keep moving while the blow
outlet selection screen is displayed. The figure
displayed on the screen shows the installed
unit viewed from the floor side. Select the flap
based on this figure. When you have selected
Back
the blow outlet, the flap with the number you
selected will move.
■You can set all flaps at once by tapping the
Bat.set.
right flap).
■When there is only one flap at the blow outlet,
such as the ceiling suspended type only the
flap that can be set will be displayed.
For an FDK with a left/right flap, select the upper/lower flap or left/
right flap.
When you select the upper/lower flap (①):
When you select the left/right flap (②):
Back
4
Select one of the upper limit positions from 1 to 6 for the flap
motion range.
After you select the range, tap the
Set
Back
－ 28 －
button (except for FDKs with a left/
№②
制
№①
御
箱
№④
配管側 ドレンホース側 Drain hose side
Pipe side
ルーバ№
Louver No.
［FDTの場合］
[For FDT]
☞4
☞8
Set button.
№③