Mitsubishi RC-EX3 User Manual page 72

■ "In operation for defrosting." display
20 ： 20 (Tue)
Heating
Set temp
Timer
In operation for defrosting.
F1: High power F2: Energy-saving
■ "In operation for heating standby." displayed
20 ： 20 (Tue)
Heating
Set temp
Timer
In operation for heating standby.
F1: High power F2: Energy-saving
■ "In operation for warming up." display
20 ： 20 (Tue)
Cooling
Set temp
ON
In operation for warming up.
F1: High power F2: Energy-saving
When frost forms on the OU, the heating performance will decrease.
Menu
This will cause the unit to automatically switch to defrost operation, and
hot air will stop blowing out from the IO.
Direction
The message "In operation for defrosting." will be displayed on the
message display. After the defrost operation has completed, "In
operation for defrosting." will disappear, and the unit will switch back to
its normal heating operation.
To prevent any cold air blowing out from the IO at the start of a heating
Menu
operation, the unit stops the fan and displays "In operation for heating
standby." on the message display.
Direction
When the unit is ready to blow out hot air, the message "In operation for
heating standby." disappears, and the unit will start heating operation.
When you select to enable warming up by the Set ON timer by hour (☞
Menu
page 39) or Set ON timer by clock (☞page 41), the operation will
start 50 to 60 minutes earlier, which is predicted based on the previous
Direction
warm up operation, so that the room will be close to the set temp by the
time it reaches the operation start time.
During the warm up operation, the message "In operation for warming
up." will be displayed on the message display.
This message will disappear at the time set for operation start.
－ 70 －