Energy-Saving Operation - Mitsubishi RC-EX3 User Manual

Energy-saving operation

Use this operation to save energy. Set temp is fixed at 28°C in the cooling operation or 22°C in the heating operation.
Since the capacity is controlled automatically based on the outdoor temperature, energy can be saved without losing
comfort.
Energy-saving operation must be set to the F1 or F2 switch (☞page 63)
Energy-saving operation is set to the F2 switch as the factory setting.
16 ： 04 (Mon)
Auto
Set temp
Timer
In operation for energy-saving.
F1: High power F2: Energy-saving
1
Push the F1 ( F2 )switch to start the energy-saving operation.
Menu
■Operation will start even if you press the F1 ( F2 ) switch while the unit is
stopped.
Direction
■Energy-saving operation is only allowed when Heating, Cooling or Auto is
selected for the operation mode.
Message "In operation for energy-saving." is displayed on the screen
during the energy-saving operation. Set temp is fixed at "28.0°C" in
the cooling operation or "22.0°C" in the heating operation. Set temp
shows "- -°C" in the automatic operation mode.
■Set temp cannot be changed during the energy-saving operation. If it is
attempted, a message "Invalid request" is displayed on the screen.
2
Energy-saving operation is terminated when you perform the
following.
・ When you terminate through a Run/Stop operation
・ When you change the operation mode
・ When you terminate the energy-saving operation with the F1 (
F2 ) switch
－ 15 －