Mitsubishi PAR-20MAA User Manual

PAR-20MAA PAR-20MAA

User Guide

User Guide
12
2
13
14
3
Operation Buttons
This sets the room temperature, The temperature setting can be performed in 1ºC
1
intervals. Setting range: Cooling 19ºC to 30ºC - Heating 17ºC to 28ºC
2
This switches between continuous or timer operation.
Press this button to switch between cooling, dry (dehumidify), automatic and
3
heating modes
4
This switches the louvre motion ON and OFF
5
This is the Lossnay interlock button
6
This resets the filter service indication display
7
This adjusts the angle of the air flow direction
This switches between the operation and stop modes each time it is pressed, the lamp
8
on this button lights during operation
9
This sets the ventilation fan speed
10
This sets the current time, start time and stop time
11
15
1
CENTRALLY CONTROLLED
CHECK
STAND BY
DEFROST
TEMP
T
TIMER SET
REMOTE CONTROLLER
PAR-20MAA
23 22
10
9
21
1Hr
ON OFF
CLOCK
FILTER
CHECK MODE
TEST RUN
ERROR CODE FUNCTION
NOT AVAILABLE
ON/OFF
1Hr
FILTER
CHECK
4
16
17
Display
This indicates when the continuous operation and time operation modes are set.
11
It also displays the time for the timer operation at the same time as when it is set
12
This indicates the operation mode
The standby symbol is only displayed from the time the heating operation starts untill the
13
heated air begins to blow
14
This indicates when the defrost operation is performed
15
This indicates when a malfunction has occurred in the unit which should be checked
16
This displays the selected temperature
17
This lamp lights when electricity is supplied to the unit
18
This lamp lights when the filter needs to be cleaned
This lamp lights during operation, goes off when the unit stops and flashes when a
19
malfunction occurs
The temperature of the suction air is displayed during operation. The display range is 8º to
39ºC. The display flashes 8ºC when the actual temperature is less than 8ºC
20
and flashes 39ºC when the actual temperature is greater than 39ºC
21
The selected fan speed is displayed
22 This displays the air direction
The current time, start time and stop time can be displayed in ten second intervals by
23
pressing the time setting button (10). The start time or stop time is always displayed
during the timer operation
20
18
19
7
6
TEST
5
8