Table of Contents
Advertisement
The USB interface is selected after connecting the USB cable to the computer and the product, and
powering on the product while the computer is turned on.
When using a USB cable for NFC transmissions, install a ferrite core as shown below to prevent signal
interference.
Recommended core characteristics: Impedance of 180 Ω @ 100 MHz
•
If the product is powered on without installing the printer driver, Windows' Plug & Play
runs. When using the printer driver, do not power on the product while the USB cable is
connected until instructed in the procedure for installing the printer driver.
•
We recommend a USB cable that is less than 5 m (16.4 feet) long.
Bluetooth Interface Connection (Standard)
Wireless communications is possible with Bluetooth-compatible computers that are placed within
about 10 m (32.8 feet) of the product.
Make sure that the Bluetooth function of the product and the computer are enabled, and then add the
product as a Bluetooth device on the computer.
The product's Bluetooth function is enabled by default and can be configured from the [Interface] menu
or the All-In-One Tool.
•
Bluetooth connection may be unstable depending on a module spec or version of
Bluetooth. When using Bluetooth connection, please test the operation beforehand in
your usage environment (computer, print data, print quantity, print frequency, etc.).
•
To use the printer driver, the communication protocol must be set to Status4. (The
initial value of the communication protocol for the product's Bluetooth interface is .)
103
Advertisement
Table of Contents
