Table of Contents
Advertisement
6
Press the ENTER key. A blinking cursor (_) appears.
>>Pitch
10.00 cpi
7
Press the
or
cursor is blinking. The character pitch can be set between 0.44 and
99.99 characters per inch, in 0.01 character-per-inch increments. You
can use the > or < key to move the cursor right and left.
If you want to abandon the setting procedure, press the CANCEL
key.
8
When the desired pitch is displayed, press the ENTER key.
9
Press the MENU key. The message display returns to Ready.
Selecting the Code Set
You can change the character code set. Available character code sets vary
depending on the current font. (The default is IBM PC-8.)
1
Press the MENU key.
2
Press the
or
Font
3
Press the > key. Press the
>Code Set
IBM PC-8
4
Press the ENTER key. A blinking question mark (?) appears.
>Code Set
?IBM PC-8
key to increase or decrease the value where the
key until Font > appears.
>
or
1-35
Using the Operator Panel
key until > Code Set appears.
Advertisement
Table of Contents
