Kyocera Mita FS-1050 Operation Manual page 88

Using the Operator Panel
Automatic Form Feed Time-out Setting
When the printer remains idle for some time, it times out and releases the
current interface; it prints whatever data is in its buffer and feeds out the
page. You can adjust the time-out length as follows:
1
Press the MENU key.
2
Press the or
Others
3
Press the > key.
4
Press the or
The default is 30 seconds.
>Form Feed
Time Out 030sec.
5
Press the ENTER key. A blinking cursor (_) appears.
>Form Feed
Time Out 030sec.
6
Press the or
cursor is blinking and so set the desired time. The time can be set
between 0 and 495 seconds, in 5-second increments. You can use the
> and < keys to move the cursor right and left.
If you want to abandon this procedure, press the CANCEL key.
7
Display the desired time and press the ENTER key.
8
Press the MENU key. The message display returns to Ready.
key until Others > appears.
>
key until >Form Feed Time Out appears.
key to increase or decrease the value where the
1-78