Handling Paper - Kyocera Mita FS-1050 Operation Manual

Handling Paper

3
The default is Off. Press the ENTER key. A blinking question mark
(?) appears. Select On using the
key.
RAM Disk Mode
? On
4
Press the > key to display >RAM Disk Size.
>RAM Disk Size
0007 Mbyte
5
Press the ENTER key again. A blinking cursor (_) appears. Change
the RAM disk size using the
setting that exceeds total printer memory. The default value for the
RAM disk is the total printer memory minus 9 MB. This parameter
may be set anywhere from 01 to 135 depending on the available
printer memory.
If you want to abandon this procedure, press the CANCEL key.
6
When the desired RAM disk size is displayed, press the ENTER key.
7
Press the MENU key and restart the printer. The setting will take
effect after restart.
You can change the MP tray mode, the paper size and type for each paper
source, the paper source and paper destinations.
MP Tray Mode
The MP tray can be used in one of two modes: first mode or cassette mode.
The MP tray can hold approximately 50 sheets of paper (A4 size, 0.11 mm
thickness).
First Mode (Automatic Manual Feeding) First Mode (Automatic Manual Feeding)
First Mode (Automatic Manual Feeding) First Mode (Automatic Manual Feeding)
The printer automatically feeds the paper from the MP tray even if another
paper source is selected. After all the paper in the MP tray is used, paper
will be fed from the paper source originally selected.
or
1-57
Using the Operator Panel
or key then press the ENTER
key. It is not possible to make a