Transparency Interleaving - Kyocera Mita FS-1050 Operation Manual

Table of Contents

Enter the page numbers before which you want to insert a page in

the Insert Before Page box. The page number range you can specify

is from 2 to 255. If you want to specify more than one page numbers,

separate them with commas. To specify a range of pages, use a

hyphen between the starting and ending numbers in the range. For

example, to insert separators before pages 5, 11, 12, 13, and 18, type

"5, 11-13, 18."

Select the Print on to Front check box to print on the separators.

Note that the Print onto Back is not applicable for model FS-1050.

If you check this check box on, each separator sheet is printed with

data reflecting its position in the entire print job. For example, the

separator between pages 9 and 10 will be printed as page 10 when

you select this check box.

Select the paper source for the separators from the Source for Page

drop down list. Note that thick paper, colored paper, etc., should be

loaded on the MP tray.

Click the OK button to return to the Print dialog box.

Load the paper you want to use for the separator(s) onto the paper

source specified in

Click the OK button to start printing.

Transparency Interleaving

This function is available when the current media type is Transparency

and the source is MP Tray (see

inserts a blank (or printed) backing sheet between the transparencies to be

printed. You can print the same content of the transparency on the backing

sheet.

Transparency Interleaving cannot be used with either Cover Mode or

Page Insert.

Note

Printing from Windows Applications

step 6

Setting the MP Tray Type

2-27

1-60

on page

). It

Table of Contents