Table of Contents
Advertisement
9
Display the desired baud rate and press the ENTER key.
10
Press the MENU key. The message display returns to Ready.
Selecting Network Interface Parameters
This section applies to the printers having the optional network interface
card installed.
Option
To allow your printer support Netware, TCP/IP and EtherTalk networks,
you will need to install the optional network interface card in your printer
and make the proper adjustments as explained in this section.
You can also have a status page for the network interface card printed out
each time the printer is turned on.
1
Press the MENU key.
2
Press the
interface names shown below appears, indicating the current
interface.
Parallel (default)
USB
Serial (option)
Option (with a network interface card installed)
3
Press the ENTER key. A blinking question mark (?) appears.
Interface
? Parallel
4
Press the
Interface
? Option
5
Press the ENTER key again.
or
key until Interface > appears. One of the
or
key until Option appears.
1-21
Using the Operator Panel
Advertisement
Table of Contents
