Kyocera Mita FS-1050 Operation Manual page 26

Table of Contents

Using the Operator Panel

1 — Software Version

This contains the firmware version and date of issue of the printer.

2 — Hardware Information

This contains information about the printer settings, such as the size and

type of paper in the paper cassette.

3 — Memory

This contains the total amount of memory installed in the printer, the

amount of available memory and the current status of the RAM disk. See

Setting the RAM Disk

4 — Page Information

This shows the print resolution, number of copies and the total page count.

5 — Installation Options

This shows which options are installed in the printer.

6 — Network Status

This shows the IP address, Subnet Mask address, Default Gateway address,

and other settings for the network interface card installed in the printer.

7 — Emulation

This shows all available emulations of the printer. The default printer

emulation is PCL6.

8 — Error Log

This shows the last three instances of the following six types of errors,

listed in order of occurrence: KPDL Error Press GO; Memory overflow

Press GO; Print overrun Press GO; File not found Press GO;

MemoryCard err Press GO; RAM disk error Press GO. The most

recent error is displayed on the top line of the Error Log. For error

Chapter 4

remedies, see

power is turned off.

9 — Toner Gauge

This shows the approximate level of remaining toner. When the value is

100, the toner container is full. The closer to 0, the smaller the amount of

remaining toner.

10 — Interface Information

This shows the default font and emulation for all interfaces installed in the

printer.

1-56

on page

. Error information is cleared when the printer's

1-16

Table of Contents