Table of Contents
Advertisement
Defining Parameters of the FM 453
7. By clicking the tabs in this window (General, Addresses and Basic Pa-
Note:
Further operation of the FM 453 is not possible with the CPU in the STOP
state.
Click the Parameters button to call up the screen for setting the parameters.
Fig. 5-3
You can return to this display at any point during parameterization by select-
ing the menu View Overview.
The FM 453 module for universal positioning is parameterized in each chan-
nel by way of parameter DBs that reside in memory on the module. Here a
key function is performed by the "Machine data" data block (DB-MD), since
it is always needed, regardless of what technological function the module
performs. All other parameter DBs are only needed as a function of the
technology involved.
You can now set the parameters of your module. This chapter gives you an
overview of the parameters that can be set.
You can use the mouse to change the size of the window for entering the pa-
rameter data and the size of the overview display.
5-4
rameters), you can
– Name the FM 353
– Change the address of the FM 353
– configure the interrupts.
Overview Display for Parameterization
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Advertisement
Table of Contents
