Table of Contents
Advertisement
Troubleshooting
Table 11-5
Operating Errors, continued
Cl.
No.
Operator control errors
1 (01) 11 (0B)
Drive, direction of rotation
Cause
Effect
Elimina-
tion
1 (01) 12 (0C)
Stoppage area
Cause
Effect
Elimina-
tion
1 (01) 90...99
System errors
(5A 63)
(5A...63)
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number
Note: Value (xx) = Hexadecimal notation of the error number.
11-14
Error Message,
Error Analysis and Elimination
Error response: "Everything OFF", as in Table 11-2
Drive turns in wrong direction.
Check drive.
Check or correct MD19.
Following "Restart" continue working using the user program.
The zero speed control range was left when the servo enable was
deactivated or when an axis standstill was reached in the PEH target
range.
Check electrical and mechanical drive disable (terminals, con-
necting cables, control element functions).
Match MD26.
Internal errors in the module.
Undefined effects possible.
If this manual is observed, the errors should not occur.
However, should this still be the case, please consult the responsible
sales department. When doing so, it is vitally important to also re-
port the exact circumstances leading to the error.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Message/
Display
Diagnostic
interrupt.
interrupt
Diagnostic
interrupt.
interrupt
Diagnostic
interrupt.
interrupt
"STAT"
"STAT"
LED
blinking.
Advertisement
Table of Contents
