Table of Contents
Advertisement
Wiring the FM 453
Safety Rules
In order to ensure the safe operation of your plant, you should introduce the
following additional measures, and adjust them appropriately to your sys-
tem's conditions:
We also recommend you carry out a risk analysis in accordance with basic
safety requirements / Appendix 1 of the EC machine directive, in order to
identify sources of danger affecting the complete system.
Further References
Please refer also to the following chapters in the S7-400/M7-400 Program-
mable Controller, Hardware and Installation manual:
For further information about EMC guidelines, we recommend the descrip-
tion in: Equipment for Machine Tools, EMC guidelines for WS/WF equip-
ment, Order No.: 6ZB5 440-0QX01-0BA1.
Standards and
When wiring the FM 453 you must observe the relevant VDE guidelines.
Specifications
Chapter Over-
view
4.1
4.2
4.3
4.4
4.5
4.6
4.7
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
An EMERGENCY STOP concept meeting appropriate safety regulations
(e.g. European standards EN 60204, EN 418 and associated standards).
Additional measures for limiting the end position of axes
(e.g. hardware limit switches).
Equipment and measures for protecting the motors and power electronics
in accordance with the installation guidelines for SIMODRIVE and FM
STEPDRIVE/SIMOSTEP.
Guidelines for handling of electrostatic sensitive devices (ESDs): Appen-
dix B.
Configuring the electrical installation: Chapter 4
In Section
Wiring Diagram of an FM 453
Description of the Drive Port
Connecting the Drive Unit
Description of the Measurement System Port
Connecting the Encoders
Description of the I/O Port
Wiring Up the Front Connector
You Will Find
4
On Page
4-2
4-5
4-12
4-16
4-19
4-21
4-28
4-1
Advertisement
Table of Contents
