Table of Contents
Advertisement
Table 11-8
General Data Errors, Machine Data Errors, Traversing Program Errors, continued
Cl.
No.
Traversing program errors Error response: "Warning"
8 (08) 26 (1A)
G function 3 unacceptable
Cause
Effect
Elimina-
tion
8 (08) 27 (1B)
M function unacceptable
Cause
Effect
Elimina-
tion
8 (08) 28 (1C)
Position/dwell time missing
Cause
Effect
Elimina-
tion
8 (08) 29 (1D)
Incorrect D-NO (>20)
Cause
Effect
Elimina-
tion
8 (08) 30 (1E)
Error, subroutine
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = Checkback signals, DB = Data block
Note: Value (xx) = Hexadecimal notation of the error number.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Error Message,
Error Analysis and Elimination
The number programmed as G function 3 is not allowed.
External block change (G50) was programmed in a block to-
gether with continuous operation for setting actual value
on the fly (G88/89).
A tool offset (G43, G44) was called up without D number.
In selecting a D number, the direction specification is missing
for the tool offset (G43, G44).
Program/block not stored.
Correct program, per cause.
The number programmed as M function is not allowed.
At least two of the M functions M0, M2, M18, M30, which
cancel each other out, are found in one block.
Program/block not stored.
Correct program, per cause.
No dwell time specified in block with G04.
Target position missing with external block change (G50).
No new actual value programmed for the function continuous
operation with setting actual value on the fly (G88/89).
Program/block not stored.
Correct program, per cause.
The number for tool offset is greater than 20.
Program/block not stored.
Correct program, per cause.
Subroutine without callup number.
Program is not stored.
Correct program, per cause.
Troubleshooting
Message/
Display
CBS
or
DB
CBS
or
DB
CBS
or
DB
CBS
or
DB
DB
CBS
or
DB
DB
11-35
Advertisement
Table of Contents
