Siemens SIMATIC FM 453 Manual page 338

Troubleshooting
Table 11-8 General Data Errors, Machine Data Errors, Traversing Program Errors
Cl. No.
General data errors
4 (04) 1 (01)
Data at time of transmission unacceptable
Cause
Effect
Elimina-
tion
4 (04) 2 (02)
Velocity level 1 incorrect
Cause
Effect
Elimina-
tion
4 (04) 3 (03) Velocity level 2 incorrect
Cause
Effect
Elimina-
tion
4 (04) 4 (04) Voltage/frequency level 1 is incorrect
Cause
Effect
Elimina-
tion
4 (04) 5 (05) Voltage/frequency level 2 is incorrect
Cause
Effect
Elimina-
tion
4 (04) 6 (06) Preset incremental value too high
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = Checkback signals, DB = Data block
Note: Value (xx) = Hexadecimal notation of the error number.
11-22
Error Message,
Error Analysis and Elimination
Error response: "Warning" see Table 11-2
Data not transmitted in appropriate operating mode.
Data not accepted.
Transmit data in appropriate operating mode.
Velocity not within the range between > 0 and max. allowable tra-
verse velocity (500 000 000 MSR/min).
Velocity does not become effective.
Input an allowed velocity value.
Velocity not within the range between > 0 and max. allowable tra-
verse velocity (500 000 000 MSR/min).
Velocity does not become effective.
Input an allowed velocity value.
Voltage/frequency specified does not fall within the range of
10 V.
Voltage/frequency level does not become effective.
Input an allowed voltage/frequency value.
Voltage/frequency specified does not fall within the range of
10 V.
Voltage/frequency level does not become effective.
Input an allowed voltage/frequency value.
Incremental value is greater than 10
Original incremental value is retained.
Input an allowable incremental value.
9
MSR.
FM 453 Servo Drive / Step Drive Positioning Module
C79000-G7076-C453-01
Message/
Display
CBS
or
DB DB
CBS
or
DB
CBS
or
DB
CBS
or
DB
CBS
or
DB
CBS
or
DB DB