Connection To Terminal Block - Mitsubishi FX3G SERIES User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition

20.4.4 Connection to terminal block

1. Terminal Screw Size
The product terminal screws are as shown in the table below.
Model Name
FX-16E-TB, FX-32E-TB
FX-16EX-A1-TB
FX-16EYR-TB
FX-16EYS-TB
FX-16EYT-TB, FX-16EYT-H-TB
2. Wire end treatment and tightening torque
Use solderless terminals of the following size.
Tighten the terminals to a torque of 0.5 N•m to 0.8 N•m.
• When 1 wire is connected to 1 terminal:
Use a crimp terminal of the size shown below, and install it as shown in the lower right figure.
• When 2 wires are connected to 1 terminal:
Use a crimp terminal of the size shown below, and install it as shown in the lower right figure.
320
6.8mm(0.27")
or less
6.8mm(0.27")
or less
6.8mm(0.27")
or less
6.8mm(0.27")
or less
Terminal Screw Size
M3.5
3.7(0.15")
3.7(0.15")
3.7(0.15")
6.0mm(0.24")
or more
3.7(0.15")
6.0mm(0.24")
or more
20 Terminal Block
20.4 Installation Work
Terminal Crimp
screw terminal
Terminal
Terminal Crimp
screw terminal
Terminal