Cautions On Connecting Peripheral Equipment By Way Of Expansion Board Or Special Adapter - Mitsubishi FX3G SERIES User Manual

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
5.2.4 Cautions on connecting peripheral equipment by way of expansion board or special
adapter.
When connecting peripheral equipment (programming tool or GOT [CPU direct connection]) by way of the
FX -232-BD, FX
3G
the connection channel is not specified with the status below, communication error may occur in the
connected peripheral equipment.
- Set to "K0" the special data register for communication format setting of the channel connecting the
peripheral equipment (CH1: D8400 or D8120, CH2: 8420).
- Set the communication parameter "PLC system [2]" of the channel connecting the peripheral equipment
to "Not set" (as shown in the window below).
46
-422-BD or FX -232ADP(-MB), set the connection channel (CH1 or CH2) as follows. If
3G 3U
5 Version Information and Peripheral Equipment Connectability
→ For details, refer to the Data Communication Edition.
Leave this unchecked.
5.2 Programming Tool Applicability