Mitsubishi FX3G SERIES User Manual page 189

FX Series Programmable Controllers
3G
User's Manual - Hardware Edition
PLC
Error operation
code at error
occurrence
Operation error [M8067(D8067)]
0000 — No error
• No jump destination (pointer) for CJ or CALL instruction
• Label is undefined or out of P0 to P4095 due to indexing.
6701 • Label P63 is executed in CALL instruction; cannot be used
in CALL instruction as P63 is for jumping to END
instruction.
6702 CALL instruction nesting level is 6 or more
6703 Interrupt nesting level is 3 or more
6704 FOR-NEXT instruction nesting level is 6 or more.
6705 Operand of applied instruction is inapplicable device.
Device number range or data value for operand of applied
6706
instruction exceeds limit.
File register is accessed without parameter setting of file
6707
register.
6708 FROM/TO instruction error
Continues
operation
6709 Other (e.g. improper branching)
6710 Mismatch among parameters
6730 Incorrect sampling time (T
Incompatible input filter constant ( )
6732
( < 0 or 100
6733 Incompatible proportional gain (K
6734 Incompatible integral time (T
Incompatible derivative gain (K
6735
(K < 0 or 201
D
6736 Incompatible derivative time (T
6740 Sampling time (T
14 Test Operation, Adjustment, Maintenance and Troubleshooting
14.6 Judgment by Error Codes and Representation of Error Codes
Contents of error
) (T 0)
S S
)
) (K < 0)
P P
) (T < 0)
I I
D )
K )
D
) (T < 0)
D D
) Scan time
S
Action
This error occurs in the execution of operation. Review the
program, or check the contents of the operands used in the
applied instructions.
Even if the syntax or circuit design is correct, an operation
error may still occur.
For example:
"T500Z" itself is not an error. But if Z had a value of 100, the
timer T600 would attempt to be accessed. This would cause
an operation error since there is no T600 device available.
This error occurs in the execution of the operation.
• Review the program, or check the contents of the
operands used in the applied instructions.
• Check whether the specified buffer memories exist in the
equipment.
• Check whether the extension cables are correctly
connected.
This error occurs in the execution of operation. Review the
program, or check the contents of the operands used in the
applied instructions.
Even if the syntax or circuit design is correct, an operation
error may still occur.
For example:
"T500Z" itself is not an error. But if Z had a value of 100, the
timer T600 would attempt to be accessed. This would cause
an operation error since there is no T600 device available.
This error occurs when the same device is used within the
source and destination in a shift instruction, etc.
<PID instruction is stopped.>
This error occurs in the parameter setting value or operation
data executing PID instruction.
Check the contents of the parameters.
<Auto tuning is continued.>
The operation is continued in the condition "sampling time
(T ) = cyclic time (scan time)".
S
11
12
13
14
15
16
17
18
19
20
183